Pressure regulator
Pressure regulators are used on high-pressure systems to maintain and control system pressure.
Unloaders
Unloaders maintain system pressure and allow liquid to bypass at low pressure when not needed.
Relief valve
A relief valve, is a secondary device used to protect the pump from over pressurization.
Pop-Off Valves
A pop-off valve is a secondary device used to protect the pump from over-pressurization.
Pulsation Dampeners
The pulsation damper absorbs pressure peaks and pressure fluctuations, caused by the pumping system.
Pressure Gauges
Pressure gauges monitor system pressure and can be used on the suction or delivery side of the system
Valve Plug Adapters
Eliminates the need for additional plumbing on your pumps’ discharge port.
Lubricants
Protect your investment by using genuine Cat Pumps lubricants
Oil Level Indicators
Oil Level Indicators are used to remotely monitor oil level in your pump system.
Inlet Regulators
Inlet regulators are designed to reduce and maintain inlet pressure to the pump.
Inlet Pressure Relief Valves
Inlet Pressure Relief Valves provide system protection from high inlet pressures.
Inlet filter
Inlet filters are used on pressurized or gravity-fed systems to filter debris out of the pump
Inlet pressure stabilizers
Inlet stabilizers help maintain consistent pressure and flow to the inlet, improving pump performance
Thermal valves
Thermostatic valves help eliminate heat build-up in a closed recirculating system by allowing cold water to enter
Pulse Pumps
Pulse pumps inject chemicals downstream of the pump at high pressure to prevent damaging the hardware.
Mag-Jet Assemblies
Jetters convert high pressure pumps into jet pumps by isolating one of the three valve chambers.
Pulsator Assemblies
Pulsator Assemblies convert high-pressure pumps into jetting pumps by creating additional pulsation in the downstream flow.
Guns
A high pressure shut-off gun allows the operator to control the flow of liquid from the pump to the nozzle
Lances/Nozzles
Lances vary the distance between the gun and the nozzle. Nozzles control the opening and characteristics of the jet.
Bell Housings
Die-cast aluminum bells maintain alignment between motor and pump and are easy to install
Couplings
Couplings are used for compact direct mounting to hydraulic or electric motors.
Clutches
Clutches are used to engage/disengage the pump and drive device to meet flow demands.
Chemical Injectors
Chemical Injectors provide and regulate chemicals into pump stream.
LPS Monitors
Low pressure seal monitors are designed to sense water leakage past the low-pressure seals.
Pressure Switches
Pressure-activated control device to control on-off operation of low amp system components.
Easy Start Valves
Easy Start Valves are designed to relieve pump discharge line pressure during system start-up.
Flow Switches
Flow-activated control device to shut off low and system components.
Thermostats
Thermostats allow users to adjust and maintain the temperature of a heater in a high-pressure water system.
Throttle Controllers
Throttle Controllers are used to reduces engine rpm when pump is in bypass.
Service Tools
Cat Pumps tools make maintaining our products even easier.
